Maintenance And Inspection; Transportation And Storage - MSW BOH-1050-2 Manuel D'utilisation

MAINTENANCE AND INSPECTION

1. Inspecting the tool
Since use of a dull tool will cause the motor to malfunction, it should be replaced with a new one
without delay when abrasion is noticed.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tightened. Should any of the
screws be loose, retighten them immediately. Failure to do so could result in serious hazard.
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power tool. Exercise due care to ensure the winding
does not become damaged and/or wet with oil or water.
4. Inspecting the carbon brushes
The motor employs carbon brushes which are consumable parts. When they become worn or near
"wear limit", it could result in motor trouble. When an auto-stop carbon brush is equipped, the motor
will stop automatically. At that time, replace both carbon brushes with new ones. In addition always
keep carbon brushes clean and ensure that they slide freely within the brush holders.
5. Installing drills
Never hold the chuck body with one hand and use the drill power to rotate the drill body to
loosen or tighten drills. You may severely injure your hand. Always check whether the drill is properly
mounted in the chuck.
6. Drilling (concerning BOH-1800 and BOH-1800-I)
When drilling in smooth hard surfaces such as metal, use centre punch to mark the desired hole
location. This will prevent the drill from slipping off centre as the hole is started. The workpiece should
be secured in a vice or with clamps to keep it from turning as the drill rotates. Check drill to make
sure it is firmly locked in the drill chuck.
7. Service
When making repairs, use only identical replacement parts. In such cases please contact our service
centre. Use of any other part may create a hazard or cause product damage. Do not attempt to modify
tools or use accessories which are not recommended. Any such alteration or modification is misuse
and could result in a hazardous condition leading to possible serious injury. It will also void the warranty.
8. Cleaning the device
To keep the device clean, clean it using a soft cloth damped in water with soap. Never use brushes or
other cleaning tools that may scratch/damage the device. Remember to prevent water from penet
rating the device through the vents in the housing of the device. Clean the vents with a paintbrush and
compressed air.

TRANSPORTATION AND STORAGE

Shaking, crashing and turning upside down of the machine should be prevented when it is transported. Store
it in a properly ventilated surrounding with dry air and without any corrosive gas.
20
Rev. 20.10.2016