• Attach the seat shell (9) to the rear frame part (10).
• Use 4 M6x15 bolts (5) for this purpose. A female thread can be found in
the frame.
D
2
10
E
5.2. Attachment to the Cruiser
Note
The direction of travel is not important for installing the Cart on the
Cruiser.
• Take the belts (11) and mount them as shown in the pictures below.
A
11
4
• Loop the fastening belts underneath the Cruiser.
• Push the fastening belts through the slits intended for them, pull them
tight and at the same time adjust the holding brackets to the width of
your Cruiser.
B
9
5
4
3
• Secure the belts with the belt clamp.
• Shorten the belt if it is too long.
C
Note
The belt is designed to accommodate a 10" scooter. If you shorten it
for a 6.5" scooter, it will no longer be usable for a 10" scooter.
Note
If the scooter begins beeping steadily after the board is mounted, then
the kart may be attached too tightly. Loosen the straps. If the scooter
continues to beep, consult the service notes in the scooter operating
instructions or contact Hama support.
• Regularly check that the fastening belts are securely attached and pulled
tight.