Axis Q7920 Mode D'emploi page 11

AXIS Q7920 Chassis
Connect Power
The AXIS Q7920 has two On/Off switches. To switch off power to the AXIS Q7920 both power
supplies must be switched off.
Before switching on power to the AXIS Q7920, make sure the unit is properly grounded by using
the grounding screw.
Ensure that the correct AC power cord for your region is used.
WARNING
• To prevent the risk of electrical shock when in contact with the unit casing, only
earthed/grounded power cords should be used to power the AXIS Q7920.
• Protection against overcurrents, short circuits and earth faults should be provided in
the building installation.
• If a foreign object is accidently dropped into the video encoder chassis, always disconnect
power before attempting to remove the object.
Axis video encoder blades
S/N — (Serial Number) is identical to the units MAC/Ethernet address.
P/N — is the products model number.
Bus Connector — This is the physical interface to the I/O terminal connector on the chassis.
11