Aux-In Connection - Denver Electronics MRD-165 Guide D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles



The clock setting mode will automatically quit if no button is being pressed in a period of about 5 seconds after

pressing the " Mem/Clk-Adj " button.

The pre-set time will be re-set completely if dis-connecting the main power supply except backup battery installed.



You are recommended to switch the system into standby mode for convenience usage.

Listening to radio

Operation

Plug in the provided DAB/FM tuner antenna to the antenna socket (30) then switch on the unit by On/Standby button (6), then

press Function button (10) to select " DAB " mode then press Band button (16) to select FM mode.

Tune to the required station by pressing the Tuning Up or Down button (23/13).

Turn the Volume knob (19) to the desired volume level.

Auto tuning (on the remote control only)

Set the unit to FM mode.

Press the Scan button once on the remote control, unit will start to scan at tuning up direct until radio station received. Press and

hold the Scan button on the remote control for a second, the unit will scan to tuning down direction. If the radio data system (RDS)

broadcasting signal received, the unit will set the actual time automatically.

Turn the Volume knob (19) to the desired volume level.

Radio data system (RDS)

This is the features to display the information which released from the radio broadcast and will showed on LCD display step by step as

below by pressing the Info button(on the remote control) continuously.

Radio text program type signal strength date/time frequency mono/stereo

Digital audio broadcasting (DAB) radio

Set the unit to "DAB" mode by Function button (10).

Press the Scan button on the remote control once, unit will start to full scan from range 11b-12d one time within around 2 second.

Then press Tune up/down button (23/13) to select your desired DAB channel.

Press the Info button continuously to check the below info released by DAB.

Group name frequency  transfer rate signal strength date/time program type  scrolling text

Press the Volume knob (19) to the desired volume level.

Preset stations

You can store up to total of 40 radio stations in the memory (20-FM/20-DAB).

Set to FM/DAB mode

Turn to the desired radio station by " manual " or " auto " tuning method.

Press and hold the Mem/Clock-Adjust button (12) around four second to enable memory state, the preset station will flash on LCD

display.

Preset the Folder/ Pre up button (22) to select the desired station memory for storage.

Press Mem/Clock-Adjust button (12) to confirm the preset memory.

Repeat step 2 to 5 to store other stations.

Recall preset stations

Press the Mem/Clock-Adjust button (12) once to enable recall state

Press Folder/ Pre up button (22) to select the desired memory station.

Press Memory/Clock-Adjust button (12) to confirm the recall memory station.



The pre-set memories will be cancelled completely if dis-connecting the main power supply and back up battery did not installed.

You are recommended to switch the system into standby mode for convenience usage.



There are 3 seconds for program state, after 3 sec. This state would resume to normal tuner mode automatically.



You can overwrite a present station by storing another frequency in its place.

FM-Stereo reception



Press the " Enter " knob (3) repeatedly, the FM programs are receiving in mono and stereo mode repeatedly. In particular when

stereo signals are weak, it is preferable to receive the program in Mono.



If stereo signal is being received, the stereo indicator "

receiving.

Hints for best reception:-

FM : the receiver work with detachable DAB/FM wire antenna, made sure the antenna had plugged into the antenna socket (30)

and place it on proper location for the best reception.