Butterfly AMICUS EXPERT Manuel D'utilisation page 5

Photo 3A
4. Standing behind the robot, grip the top points of the net and fold the net down on both sides until
the net fully opens (as seen in Photo 4A). Fit the plastic Corner Brackets of the net around the
corners of your table as seen in Photo 4B.
Photo 4A
NOTE: You may attach the two shortest Velcro strips to the corners of your table underneath the
Corner Brackets to help the brackets stay down and stabilize the entire net.
5. Pull a Side Net along the side line of the table and pass its thick rubber band over the top of the
table's net standard (see Photo 5A). Then loop the rubber band around the Clamp Screw that holds
the net onto the table. Attach the Side Net's Velcro tab to its matching piece located on the Corner
Bracket as seen in Photo 5B.
Photo 5A
6. Plug your Power Supply into a power outlet and then into the power jack on the side of the Base.
Photo 3B
Photo 4B
Photo 5B
5