PEERLESS Mounts SmartMount SP740P Installation Et Assemblage page 8

Installing and Removing Flat Panel Screen
To attach screen to wall mount (A), lower hook
3
bracket (M) into pockets of wall mount. Once clips
are engaged, push down to seat clips into pockets.
Insert and tighten M5 phillips screw (K) to lock
screen to wall mount as shown in figure 3.1.
To remove screen from mount, loosen screw (K)
and lift screen off of mount.
WARNING
• Do not lift more weight than you can handle. Use ad-
ditional man power or mechanical lifting equipment
to safely handle placement of the screen.
• Failure to lock hook bracket (M) with screw (K) can
cause screen to come off mount if hit accidentally.
Hold screen securely and loosen tension knob on
4
side of mount shown in figure 4.1 to allow for tilt.
Adjust screen to desired tilt (15° forward, 5°
backward), then retighten tension knob.
Rotate screen by hand to level screen. Roll bracket
4-1
allows 2° roll adjustment.
Insert #10-32 x 1/2" flat head phillips screw (O) to
lock screen into position as shown in figure 4.2.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fingers when opening and
closing mount from the wall.
CLIP
POCKET
fig. 4.1
8 of 42
SCREEN
K
A
fig. 3.1
TENSION KNOB
ISSUED: 05-18-05 SHEET #: 095-9235-9 12-05-09
M
O
fig. 4.2