Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
GB
An accurate maintenance guarantees good functioning and long-lasting performance.
Particular care is due to the grease filter panel.
HOW TO REMOVE THE GREASE FILTER AND THE CHARCOAL FILTER
SLTC93 MATERA - SLTC94 BARI After opening the front panel, as shown in the installation
section, remove the grease filter by acting on its handle.
The charcoal filter is installed as shown in fig. 17, by fitting it into its seat which is found just
behind the metal grease filter.
SLTC97 BERGAMO Remove the grease filter by acting on its handle.
The charcoal filter is installed directly on the grease filter rear side, by hooking the charcoal filter
directly on the grease filter frame by using its specific handle.
The grease filter needs cleaning by regular hand-washing or in dishwashers ev ery two months
at least or depending on its use. In case the appliance is used in its filtering version, the active
coal filter needs to be periodically replaced.
The charcoal filter is removed by removing the grease filter first, following the instructions abo-
ve, then by pulling its special plastic tongue until it is released from its seat.
The charcoal filter is inserted by following the reverse procedure.
To clean the appliance itself tepid water and neutral detergent are recommended, while abrasive
products should be avoided.
The power cord shall be replaced by authorized personnel only.
Substitution of the LED bar:
Using an appropriate tool, remove the LED bar from its seat (refer to Fig. 19), disconnect it
electronically using the appropriate connector then substitute it with a LED bar with same cha-
racteristics.
10
Publicité
