Introduction; Important Considerations - Danfoss SonoRead 868 Mode D'emploi

User Manual SonoRead 868 Wireless Radio Receiver for meter reading
1

Introduction

The SonoRead 868 is a portable radio receiver for wireless M-Bus resource meters (currently capable of
handling Mode T1, T2, C1). SonoRead 868 is equipped with a Bluetooth interface. A rechargeable lithium
ion battery assures operating times up to 20 hours with one charge.
The SonoRead 868 is usually used in conjunction with a smartphone or tablet for mobile reading of radio
consumption meters (heat, water, electricity, gas and others).
Due to its watertight enclosure (IP64) and its mechanical rugged construction (EN 60721 class 7M3) it can
be used in harsh environments without additional protection.
Additionally, the SonoRead 868 is equipped with a serial interface to connect e.g. optical meter configura-
tion devices.
2

Important Considerations

•
The specific purpose of the SonoRead 868 is the mobile reception of M-Bus Mode T1, T2 and C1 con-
sumption meter radio telegrams and the transmission to a smartphone or tablet via Bluetooth interface.
•
The SonoRead 868 may only be operated by trained personnel.
•
The SonoRead 868 is only to be used in environments in conformity with its protection rating (IP64) and
operating temperature range (-5°C to +55°C).
•
The integrated rechargeable lithium ion battery may not be charged at temperatures below 0°C or above
+45°C (battery charging only at 0°C to +45°C)
•
Only the accompanying charging device may be used to charge the SonoRead 868. Do not operate the
charging device without the proper wall plug adapter. The charging device may only be used in dry and
weather-protected environments.
•
Do not use force to insert the round battery charger plug. Turn it until it you can gently push it into the
SonoRead 868 connector. Do not screw it too tight.
•
Charge the SonoRead 868 completely before using it the first time.
•
The SonoRead 868 is not a calibrated measuring device. The transmitted meter counts and consumptions
are of informative character only.
•
If a fault occurs, do not try to repair the unit yourself. Attempts to do so will void the warranty. Refer all
servicing to your supplier.
•
Do not open the case of the device. Do especially not remove, open or short circuit the lithium ion bat-
tery inside the device.
VUIGP102 © Danfoss | Energy Meters | 2017.09 5