Establishing A Bluetooth Connection - Danfoss SonoRead 868 Mode D'emploi

User Manual SonoRead 868 Wireless Radio Receiver for meter reading
6

Establishing a Bluetooth Connection

After the power-on of the device you should wait approximately 5 seconds before trying to establish a
Bluetooth connection. This period of time is necessary for starting up all the modules in the SonoRead 868.
Afterwards, you should go to the Bluetooth configuration page of your smartphone or tablet and perform
a device search. This process differs from device to device, so please check also the manual or online help of
your smartphone or tablet.
To verify if the correct SonoRead 868 device is found you can compare the found Bluetooth name with the
name / serial number on the back of the device (e.g. MBWBLUE 87384327).
If you are asked for an authorization code / PIN, enter four times zero: 0000.
10 | © Danfoss | Energy Meters | 2017.09 VUIGP102