GE GFW490 Manuel Du Propriétaire Et Instructions D'installation page 20

LOCATION OF YOUR WASHER
DO NOT Install the Washer:
1. In an area exposed to dripping water or outside
weather conditions. The ambient temperature
should never be below 60°F (15.6°C) for proper
washer operation.
2. In an area where it will come in contact with curtains or
drapes.
3. On carpet. The floor MUST be a hard surface with
a maximum slope of 1/2 per foot (1.27 cm per
30 cm). To make sure the washer does not vibrate
or move, you may have to reinforce the floor.
NOTE: If floor is in poor condition, use 3/4 impregnated
plywood sheet solidly attached to existing floor covering.
ROUGH-IN DIMENSIONS
FRONT
28"
(71.12cm)
*NOTE:
With Legs: 40 1/2" (102.5 cm) - (3/4" (1.9 cm) adjustability)
With Built-In Pedestal™: 46" (117 cm) - (3/4" (1.9 cm) adjustability)
With Optional Pedestal (GFXP1308): 52" (132.1 cm) - (3/4" (1.9 cm) adjustability)
Stacked: 78 1/4" (198.8 cm)
Installation Instructions
39"* 46"*
(99cm) (117cm)
IMPORTANT:
Minimum Installation Clearances
• When installed in alcove: Sides, Rear,
Top = 0 (0 cm)
• When installed in closet: Sides, Rear,
Top = 0 (0 cm), Front = 1 (2.54 cm)
Consideration must be given to provide
•
adequate clearance for installation and service.
Closet doors must be louvered or otherwise
•
ventilated and have at least 60 square inches of
open area. If the closet contains both a washer
and a dryer, doors must contain a minimum of
120 square inches of open area.
SIDE
54 3/8"
(138.2cm)
20
35"
(88.9cm)
39"*
(99cm)
46"*
(117cm)
Built-In
Pedestal™
models
only