Laica HYDROSMART VENEZIA Instructions Et Garantie page 12

EN VENEZIA tap filter
6) To install the connector with the M adapter, proceed as follows:
Remove the fastening ring from the connector and take the adapter L with diameter Ø 21 mm complete with seal
-
N, then assemble the three pieces as described in figure 6A, 6B, 6C.
6A
Loosen the fastening band with a flat head screwdriver and remove the two rubber seals inside the adapter M
-
(fig. 7a, 7b).
7A
- Choose the best seal: only the one with the biggest diameter (Fig. 8A) or both with one inserted inside the other
(fig. 8C). Then, insert them in the adapter, pressing firmly and taking extra care over which way up they are
inserted (fig. 8D).
8A
Install the adapter M on the tap and tighten the fastening band using a flat
-
head screwdriver to secure it firmly to the tap (fig. 9A and B).
9A
7) Remove the HYDROSMART™ filter from its packaging and rinse it under running water. Now hook the filter to
the connector as shown in figure 11A, 11B, 11C.
11A
03
8B
9B
11B
12
6B
7B
8C
- Screw the connector onto
the ring (fig. 10).
10
11C
03
6C
8D