Operation - Davey Regulmatic Notice D'installation, D'utilisation Et D'entretien

3. Operation

The button « Mode » has to be pushed once to change from
« Auto » mode to « Salt System On » mode.
- In « Auto » mode, (LED « Auto » ON) the salt system control will
supply the 230V (or will cut the 230 V power supply) according to the
value of the oxidizing (Chlorine) measured by the probe.
- In « Salt System On » mode (LED « Auto » OFF), the salt chlorination
system will be permanently under 230 V voltage during the filtration time
as if the unit was connected in parallel with the filtration pump, to the
230V power supply.
Value of the oxidizer (Chlorine) in the water
According to the measurement of the probe, the control system will
display on the 5 LED, the oxidizing value (Chlorine) in the water.
Low OK High
Fig. 1 - All the 5 LED are OFF or
only the first LED is ON:
The value of the oxidizer (Chlorine)
measured by the probe is too low.
The control system will supply the
230V to the salt chlorination
system.
nd rd
fig. 2 – The 2
or 3 LED 2 is ON
The value of the oxidizer (chlorine) measured by the probe is correct. If
this value increases, the control system will cut the supply of the 230V to
the salt chlorination system.