Declaration Of Compliance; Gas Technical Data Table; Electrical Technical Data Table; Installation Of The Appliance - Lotus cooker CF4-8ET Instructions Pour L'installation Et L'emploi

Table des Matières

Les langues disponibles

The manufacturer declares that the appliances are compliant with the prescriptions of the EEC norm 2009/142 for the

gas part and with norm 2006/95/CE, 2004/108/CE for the electric part. The installation must be done observing the

norms in force particularly concerning room ventilation and discharging gas emissions.

N.B.: The manufacturer declines any responsibility for direct or indirect damage caused by improper or incorrect

installation, alterations, maintenance or use of the appliance, as in all the other cases considered in the items of our sales

conditions.

DIMENS.

MODEL

CF4-8G

CF4-8GEM

CF4-8GEMS

DIMENS.

MODEL

CF4-8ET

80x65x87

CF4-8ETS

CF4-8ET

80x65x87

CF4-8ETS

80x65x87

CFC4-8ET

80x65x87

CFC4-8ET

80x65x87

CF4-8G

80x65x87

CF4-8GEM

80x65x87

CF4-8GEMS

•

Installation, any transformations for other types of gas and starting can be done only by qualified personnel

according to the standards in force.

•

The gas systems, electrical connections and the rooms where the appliances are installed must be in accordance

with the standards in force in the country where they are installed; particularly, the appliance must be installed in a well

aired room, possibly under a suction hood to guarantee complete evacuation of the exhaust gases that are formed during

combustion; the necessary air for combustion is 2 m 3 /h per kW of installed power.

Caution: According to international directives, the appliance must be connected to the mains using a circuit breaker

which cuts off the flow of electricity in all poles. The distance between the disconnected poles must be at least 3 mm

Make sure that the air intake into the room where the appliance is installed is sufficient for an adequate change of air, as

specified by regulations in effect.

The appliances installed in buildings open to the public must satisfy the following requirements.

Installation rules

The installation and maintenance of the appliance must be done according to the correct procedures and

regulation texts in use, particularly:

•

safety standards for the prevention of fire and panic.

Connection and installation of appliance, ventilation and exhaust removal systems, shall be done according to the

Manufacturer's instructions and by qualified technicians and according to the regulations in effect. The electric wiring

shall conform to the regulations in effect. All fire prevention codes shall be observed.

General indications (Rules valid for G.B. only)

For all appliances:

Gas safety Regulations, 1984; Health and safety at Work Act, 1974 Codes of Practice, BS 8173, 1982, The

Building Regulations 1985; The Building Standards Regulations, 1981, the IEE Regulations and the by-laws of the

local Water Undertaking.

The local gas Region or LPG supplier and the local authority and the relevant recommendation of the British

Standards (latest editions) concerned.