Franke FDL 307 W Instructions D'installation, Mode D'emploi Et D'entretien page 9

Mounting the hood body
• Screw the two screws 12d supplied onto the brackets 7.1.
• Hook the hood body onto the bracket 7.1, centring it around
the vertical line.
• Use the adjusting screws 12d underneath the hood to level the
hood body.
Note: The Hood body should be secured to wall studs. If neces-
sary, install a wood support behind the dry wall, flush mounted
between 2 studs. This will provide the necessary structure and
support for mounting.
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the
chimney using a rigid 6" duct.
• Install the damper 10 ø 6".
• Fix the duct in position using sufficient pipe clamps (not sup-
plied).
DUCTLESS VERSION AIR OUTLET
• Put connection 15 into the connection support 7.3.
• Fix to the support using the 2 screws 12e supplied
• Connect the air outlet connection 15 to the hood body outlet
using either a rigid ø 6" pipe(not supplied).
• Ensure that the activated charcoal filters have been inserted.
EN
Connections
12.d
10
15
12e
7.1
9 9