Publicité
WARN Industrial Hoists
Mounting the Controller (Electric Hoists)
1 Remove the screws holding cover to controller
bracket.
2 Mount the controller in an upright or vertical
orientation so that water will not collect in the
cover.
3 Mount controller in a location free of excessive
vibration. Use lock washers to prevent
mounting nuts from loosening.
4 Mount controller so it is protected from
damage by tools or heavy objects.
5 The controller can be mounted in a location
exposed to the weather; but it should be
protected from the possibility of damage from
tools or heavy objects.
6 Use the mounting dimensions shown.
Foot print
of controller
cover
Mounting dimensions for typical controller
FIRE HAZARD
Failure to observe these instructions could
lead to severe injury or death.
• Never mount controller in an area where it
may be used as a step or where tools will be
hung or placed on it.
• Always avoid damage to terminals located
on top surface of the enclosure.
• Always keep tools and other electrically
conductive equipment away from terminals
at all times.
6.7 in (170 mm)
5.25 in (133 mm)
6
WARNING
Publicité
