Publicité
WARNING
CUT AND BURN HAZARD
Failure to observe these instructions could
lead to minor or moderate injury.
To avoid injury to hands and fingers:
• Always wear heavy leather gloves when
handling wire rope.
• Never let rope slip through your hands.
• Always be aware of possible hot surface
at hoist motor, drum or rope during or after
hoist use.
• Never mount controller in an area where it
may be used as a step or where tools will be
hung or placed on it.
• Always avoid damage to terminals located
on top surface of the enclosure.
• Always keep tools and other electrically
conductive equipment away from terminals
at all times.
WARNING
Failure to observe these instructions could
lead to property damage, severe injury, or
death.
• Never exceed the maximum recommended
hydraulic pressure or flow for any of the
components used.
• Always connect the hoist to the hydraulic
system as shown in the hydraulic schematic.
• Always use the correct type of control valve
as shown in the hydraulic schematic.
• Always Stand clear of hydraulic lines
during operation.
• Always install hydraulic components
in accordance with manufacturer's
recommendations.
General Safety Precautions
CAUTION
MOVING PARTS ENTANGLEMENT
HAZARD
Failure to observe these instructions could
lead to minor or moderate injury.
• Always use a hook with a latch
• Always insure hook latch is closed and not
supporting load.
• Never apply load to hook tip or latch. Apply
load only to the center of hook.
• Never use a hook whose throat opening has
increased, or whose tip is bent or twisted.
NOTICE
AVOID HOIST AND EQUIPMENT
DAMAGE
• Never "jog" rope under load. Shock loads
can momentarily exceed capacity of rope and
hoist.
• Never use hoist to secure a load during
transport.
• Never submerge hoist in water.
• Always store the remote control in a
protected, clean, dry area.
3
Publicité
