Trace Series Inverter/Charger Dc Conduit Box; Installation Instructions - Xantrex TR-CONDUIT BOX Instructions D'installation

Trace Series Inverter/Charger DC Conduit Box

( -
TR CONDUIT BOX
Safety Instructions
Misusing or incorrectly connecting the Trace Series Inverter/Charger
damage the equipment or create hazardous conditions for users. Read the following safety
instructions and pay special attention to all Caution and Warning statements in this document and
your Trace Series Inverter/Charger Installation Manual (Part #: 975-0367-01-01).
1. All electrical work must be done in accordance with local, national, and/or international
electrical codes.
2. All electrical work must be done by a qualified installer.
3. Before installing or using this device, read all instructions and cautionary markings located in
(or on) the manual, the inverter, the batteries, and any other associated equipment.
WARNING: Shock hazard
The Trace Series Inverter/Charger accepts power from more than one source (both AC and DC).
Always verify ALL power is off before opening the chassis of the Trace Series.
To install the
1. Carefully unpack the
2. Verify the Trace Series Inverter/Charger (item A in Figure 1) is completely de-energized.
3. Remove the cover screw (item B in Figure 1) from the Trace Series.
4. Align the
surface (wall) as the Trace Series using the proper mounting hardware (item H in Figure 1).
5. Remove the appropriate conduit knockout(s) (items E/F in Figure 1). The knockouts
accommodate ¾ in. (19 mm), 1 in.(25.4 mm) and 2 in. (50.8 mm) conduit fittings.
6. Connect the incoming conduit to the
7. Route the DC wires to the Trace Series. Connect them according to the wiring diagrams and
instructions in the Trace Series Inverter/Charger Installation Manual.
Important:
Trace Series Inverter/Charger Installation Manual for more details.
8. Connect a DC ground wire to the Trace Series chassis ground lug.
If installed, remote and BTS cables can be routed and attached to the side of the DC wiring box
using the included cable tie retention slots (item G in Figure 1, 3 places).
Important:
• Torque battery and ground connections on Trace Series terminals to 10-15 ft-lb.
• Do not interchange the screws from the inverter (item C in Figure 1) with the screws provided
with the
9. Attach the conduit box cover (item D in Figure 1) using the hardware provided (item B in
Figure 1). Secure the cover to the top of the Trace Series using the screw removed in Step 3
(item C in Figure 1).
10. Apply power to the Trace Series and test for proper operation as described in your Trace Series
Inverter/Charger Installation Manual.
975-0368-01-01

) Installation Instructions

-
TR CONDUIT BOX
-
TR CONDUIT BOX
-
TR CONDUIT BOX
A right angled DC crimp lug may be required in larger DC cabling installation. See
- (item B in Figure 1); they are different sizes.
TR CONDUIT BOX
Trace Series
:
. Remove all packing materials.
with the left side of the Trace Series chassis. Secure it to the same
-
TR CONDUIT BOX
- Installation Instructions
TR CONDUIT BOX
975-0368-01-01
Revision B
-
TR CONDUIT BOX
using a conduit fitting.
may
1