Connecting A Network Cable - Yamaha MusicCast VINYL 500 Mode D'emploi

 If using this unit's PHONO OUT jacks
Sources that can be played back: Records
This unit's network functionality cannot be used.
This unit
(back panel)
RCA stereo cable
(supplied)
Pre-main amplifier or
phono equalizer, etc.
(PHONO input jacks)
AC adaptor
(supplied)
Connect to AC outlet
PHONO IN

Connecting a network cable

To use a wired connection to the network, connect this unit to your router using
a commercially-available STP network cable (CAT-5 or higher straight cable).
To connect wirelessly to the network, proceed to "Connecting the unit to the
network" ( page 23).
Network cable
LAN
Wireless router
NOTE

Connect the network cable before you turn on the power of this unit.

You can connect to the network via a wired connection regardless of whether
the WIRELESS switch located on the back panel of this unit is set to AUTO or
OFF. ( page 14)

If the unit is already wirelessly connected to the network, put this unit's power
in standby mode, connect the network cable, turn the back panel WIRELESS
switch OFF, and then turn on the power. ( page 14)
|
Getting ready Making connections
This unit
(back panel)
Internet
Modem
En
19