Air Bubble System - Aqua Finesse Timberin Manuel General

A powerful bubble system that also has a nice massage effect. A special pump blows streams
of air into the water through 6 (HT150) special air vents. The system also includes check valve,
hose, connections, pressure switch for the air blower.
water the water in the hose can be removed by starting the air blower. Let the water drain from the hot
tub and repeat the procedure at least three times. The base of the bubble system for the HT150 has 12
holes for air vents, which are screwed into a lower part (see picture). Note! Use Silicone or an equivalent
material to seal the base of the jet from above as well as the threads. Tighten by hand. The picture below
illustrates the connected hose system (Basic).
www.badetonneholz.de
www.badestampselges.com

AIR BUBBLE SYSTEM

BUBBLE SYSTEM PARTS:
USING A HOT TUB WITH BUBBLE SYSTEM IN
If you have a hot tub equipped with a bubble system and
you intend to use it in the winter, then the hose and air
jets have to be protected from freezing. When the air
blower isn't operating but there is still water in the hot
tub then the hose will fill with water all the way up to
the check valve.
after 15 minutes maximum, so that the water in the hose
does not have time to freeze. When the hot tub is drained of
│
www.bainnordiques.fr
Updated 01 20 2017
THE WINTER
REMEMBER
│
www.vildmarksbadtre.dk
│
www.vascatinozzabotte.it
to start the air blower
│
www.hottubhouten.nl