Table des Matières
Publicité
ASSEMBLY INSTRUCTIONS
Read all information before assembling/usage.
1. Drill a ø 47 mm hole for the light. Refinement might be needed, in that case use sandpaper
or a file.
2. The light can be used with wall thicknesses up to 60 mm.
3. Thread the wires through the hole. Assemble with the white gasket under the crown of the
lamp. Also use silicone on the surface that will lie against the wall in order to prevent any
leaks due to possible irregularities. NOTE! Remove the crown from the light before
beginning assembly, put it back after the silicone has dried.
4. The black gasket is put on from behind and then the nut is tightened over it. Attach the nut
using hand force only and wipe away excess silicone from the inside.
5. The control panel is assembled outside the spa/bath/pool in the same way as the light, but
without the use of silicone. Largest diameter is 35 mm, thus use a ø 35 mm hole saw. NOTE!
Applies only if you have a control panel. Warning! The control panel is not be mounted
inside the bath or in a place where it will be regularly exposed to water.
6. Connect the PCB output cable from the light to the control panel.
7. Put the transformer somewhere safe and connect the power cable from the control panel to
the transformer.
8. Connect the transformer to the grid and test the light according to the manual.
www.badetonneholz.de
www.badestampselges.com
│
www.bainnordiques.fr
Updated 01 20 2017
│
www.vildmarksbadtre.dk
│
www.vascatinozzabotte.it
│
www.hottubhouten.nl
Publicité
Table des Matières
