Publicité
Les langues disponibles
Les langues disponibles
Factory setting value:5.0 Sec Setting range :1-6
Cod : Cod define the password mode. If this value is ON it means you must know the password to enter menu. Push the SET button to
change the value, the value starts blinking. Use UP and DOWN buttons to set desired value then push the SET button to save. Use UP and
DOWN buttons for setting desired value then push the SET button for save.
Factory setting value : OFF Setting range : ON / OFF
Sch : Sch define the variac limit switches mode. If this Value is OFF the device uses mechanical limit switches. If this Value is ON device does
not use mechanical limit switches because electronic card's software calculate the values automatically. Push the SET button to change the
value, the value starts blinking. Use UP and DOWN buttons to set desired value then push the SET button to save.
Factory setting value : OFF Setting range : ON / OFF
buZ : buZ sets the buzzer mode . If this value is ON this means buzzer is ACTIVE. If this value OFF it means buzzer is INACTIVE. Push the SET
button to change the value, the value starts blinking. Use UP and DOWN buttons to set desired value then push the SET button to save.
Factory setting value : OFF Setting range : ON / OFF
SYSTEM RESET IN CASE OF FAULT
An error message may appear during start-up or during operation.
The cause may be anomalous voltages when the reset setting is not automatic, or in-line harmonics or insertion
currents.
In this case one or more instruments displays "ERR"
To obtain a system reset, simultaneously press the UP ARROW / DOWN ARROW keys
After a few seconds, release the keys. The input voltage is displayed
Regular operation is confirmed by the lighting of the BLUE led "output OK"
MICRO - SERVO REGULATOR
Voltages must be controlled once a day with the voltmeter on the regulator. If you don't have this option, you must buy a regulator having overvoltage
protection.
If your regulator has an overvoltage and phase protection unit, electricity is cut automatically when your regulator generates an over or low voltage. If
Publicité
