Installation Instructions - Mistral LAZS430SB Instructions D'installation Et Guide De L'usager

2. INSTALLATION INSTRUCTIONS
TOOLS NEEDED TO INSTALL THE RANGE HOOD

Philips screwdriver

Hammer and flat blade screwdriver

Sheet metal sheers

Pair of pliers

Scissors (to cut duct tape)

Duct tape

Marker or pencil

Level

Measuring tape
BEFORE INSTALLING THE HOOD

For the most efficient airflow exhaust use a straight run or as few elbows as possible.

Vent unit to the outside only.

Two people are required for installation.

Remove the range hood from the carton packaging and place on a flat surface for
assembly.
ELECTRIC REQUIREMENTS
CAUTION: THIS APPLIANCE SHOULD BE PROPERLY GROUNDED.

This hood must be power supplied 120 V, 60 Hz, and connected to an individual, properly
grounded circuit (3-prong outlet).

If the electrical supply does not meet above requirements, call a licensed electrician before
proceeding.

Route house wiring as close as possible to the installation location, in the ceiling or back wall.

The hood must be connected to the house wiring in accordance with the local codes and norms.
WALL FRAMING FOR ADEQUATE SUPPORT
THIS VENT HOOD IS HEAVY. ADEQUATE STRUCTURE AND SUPPORT MUST BE PROVIDED IN ALL TYPES
OF INSTALLATIONS. IF MOUNTING ON DRY WALL, THE HOOD MUST BE SECURE TO VERTICAL STUDS
IN THE WALL, OR TO A HORIZONTAL SUPPORT.
5