Vetus GWDS Instructions D'installation Et Manuel D'utilisation page 9

3.2 Summary of connections
1 Shower
2 Washbasin
3 Air conditioning
4 Drain
3.3 Connection 1 (shower)
A shower can be connected to the side connection.
Using a sharp knife, remove the closed side of the connection
piece (A).
- Fit the connection piece (A) over the side connection and
clamp this with the plastic clamp (B).
- Fit a reducing piece (not supplied) of ø 40 mm to the correct
hose diameter in the connecting piece (A) and clamp this
with the plastic clamp (C).
- Fit the hose.
GWDS
3.4 Connection 2 (washbasin)
Using a sharp knife, cut open one of the circles indicated.
Trim the cut surface well. Remove any sawdust from the
GWDS.
- Place the connection piece (C) in the opening.
- Place a ø 40 mm reducing coupling (not supplied) to the
desired hose diameter in the connection piece (C) and attach
it with the help of the hose clamp (D).
- Fit the hose.
3.5 Connection 3 (air conditioning)
Drill an ø 8 mm hole in the
hose connection, through
the container.
Attach the ø 12 mm hose.
ENGLISH
7
110120.01