Charging Instructions - Joerns Healthcare Oxford Elevate Manuel De L'utilisateur Et Garantie

Oxford
®
Elevate

8. Charging Instructions

The batteries are located in the battery pack and are charged via an off board desktop charger unit.
When the battery pack needs charging it is removed from the lift and fitted to an off board
charging unit.
1. Remove the power pack from the lift. The pack is retained by a simple latch at the top of the
power pack. Lift the latch and the power pack will be released.
2. Fit the power pack to the charging unit. The location and latching of the power pack to the
charger is the same system as used on the lift.
3. Plug the charger mains plug into a suitable mains outlet and switch the mains supply ON.
4. Charging is automatic and will fully charge the batteries over a period of eight to twelve hours.
Note: Even if the charger is left plugged in for extended periods it will not allow the batteries
to overcharge.
5. To return the lift to service, disconnect power supply remove the power pack from the charger.
Fit the power pack to the lift and make sure the latch holding the pack in place is fully
engaged. "Click" in place. The charging of Oxford electric lifts is simple and straightfor
ward, but it is important to follow the charging instructions closely. Please pay particular attention
to the following warnings, they will help you avoid problems with discharged batteries.
16
294000.10065 Rev. B
Removable Battery Pack
Hand Control
Legs Open/Close,
Boom Raise/Lower
Control Box
Emergency Stop, Raise/Lower
E ng lish