Baker Hughes Mentor Visual iQ VideoProbe Manuel De L'utilisateur page 110

Appareil portable

Table des Matières

Reference Plane – The plane, defined by three or more points on a

reference surface, from which the perpendicular distance to other

surface points is computed. A blue square indicates the reference

plane position in the measurement image 3D point cloud view.

Note: A reference plane is calculated as flat, even if the surface the

plane rests on is not flat. This is a potential source of error.

Reference Profile Line – Area Depth Profile lines set by the

measurement cursors that follow the surface contours and are used

to determine the area and reference planes for the profile slices.

Reference Surface – Unaltered part surface to be used as a reference

for various measurements.

Result Slice – The Area Depth Profile profile slice that includes the

highest or lowest point and is shown on the image and in the point

cloud.

Surface Mask – Shows surface points very close to the measurement

reference plane in green to help the user establish accurate reference

planes with Measurement Plane and Depth, Depth Profile, and Area

Depth Profile measurements.

Yellow Mask on Image – With 3D Phase Measurement, indicates

surface data may be of low quality for measurement. The potential

for reduced accuracy may exist, especially for depth or small

measurements. Yellow mask areas are often caused by surface to

surface reflections. Changing the probe orientation to make such

reflections bounce away from the probe tip may improve data quality

and reduce or eliminate yellow mask areas.

110

08/2019

Table des Matières

Chapitres

Table des Matières