Qlima SRE 3130 C Manuel D'utilisation page 85

Masquer les pouces Voir aussi pour SRE 3130 C:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
transportation cap
Regularly inspect the fuel filter as well:
1
Remove the removable tank from the heater and remove the fuel filter
Some drops may leak from the filter; keep a cloth at hand.
2
Remove the dirt and water by gently tapping the fuel filter upside-down against a
hard surface. (Never clean it with water!)
3
Reinstall the fuel filter into the heater.
We recommend to remove dust and stains on the outside of the heater from time to
time with a damp cloth, otherwise these may cause stains that are hard to remove.
Do not remove any components yourself. Always contact your dealer for repairs.
When the power cord is damaged, it may only be replaced by an authorised
engineer. Use a new original cord.
Q
STORAGE (END OF THE HEATING SEASON)
At the end of the heating season, store the heater in a dust-free place in its original
packaging. Any unused fuel cannot be used the next heating season. We therefore
recommend that you burn up all fuel prior to storing. If there is still some fuel left, do
not throw it away, but dispose of it in accordance with the local regulations for the
disposal of domestic chemical waste.
Always start the new heating season with fresh fuel. When you start re-using the
heater follow the instructions again (starting from section A and as specified).
R
TRANSPORTATION
Take the following measures to avoid fuel leakage during the transportation of the
heater:
1
Let the heater cool down.
2
Remove the removable tank from the heater and remove the fuel filter.
Some drops may leak from the filter; keep a cloth at hand. Store the fuel filter and
the removable tank outside the heater.
3
Place the transportation cap into the position of the fuel filter. Press it tight. The
transportation cap will, as much as possible, prevent oil leakage from the heater
during transport.
4
Always move the heater in an upright position.
5
Make the fixed tank empty with a fuel pump before transportation or in case of
wrong or dirty fuel. First remove the fuel filter and then insert the fuel pump into
the empty fixed tank. Follow the same procedure if the fuel tank contains water.
4
85

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sre 3131 cSre 3132 c

Table des Matières