Footswitch - Fender Acoustic Junior Mode D'emploi

NOTE: THE MAGNETIC OVERLAY LABEL INCLUDED IN THE AMPLIFIER'S PACKAGING SHOULD BE APPLIED
TO THE OPTIONAL MGT-4 FOUR-BUTTON FOOTSWITCH IN ORDER FOR THE FOOTSWITCH TO BE USED WITH
THESE AMPLIFIERS. SIMPLY PLACE THE MAGNETIC LABEL ON TOP OF THE FOOTSWITCH (OVERLAY SHOWN
IN PLACE ABOVE).
X: MODE LEDS: Indicate whether channel 1, channel 2 or looper mode is selected using MODE BUTTON (Y).
Y: MODE BUTTON/LED: Press repeatedly to select among channel 1, channel 2 or looper, as indicated by MODE LEDS (X).
In tuner mode, illumination of this red LED indicates a greater degree of flattened pitch.
Z: FUNCTION BUTTON/LED 1: Press for "FX BYPASS" function that disables effect in active channel. In tuner mode, illumi-
nation of this red LED indicates flattened pitch closer to correct pitch. See "Looper" section for looper "REC/DUB" function
of this button/LED.
AA: DISPLAY WINDOW: Displays selected mode and function information.
BB: FUNCTION BUTTON/LED 2: Press repeatedly for "FX SELECT" function that scrolls through effects—from top to bottom
of control panel EFFECTS DISPLAY (E)—in active channel (repeats at end of list). In tuner mode, illumination of this red LED
indicates sharpened pitch closer to correct pitch. See "Looper" section for looper "PLAY/STOP" function of this button/LED.
CC: FUNCTION BUTTON/LED 3: Controls time-based effect tempos (echo, delay, delay plus chorus, delay plus reverb) for
both channels. Tap at least twice at desired rate to set delay time for active effect(s); red LED above button will flash in time
accordingly. TAP TEMPO is global for all modes, enabling switching among effects while keeping same tempo.
Hold this button to enter hands-free tuner mode, in which the tuner reads the audio signal from either channel 1 or channel
2 as selected by the MODE BUTTON (Y). The four red LEDs along the top of the footswitch (MODE and FUNCTION BUTTON
LEDs) indicate varying degrees of sharpened and flattened pitch (illumination of the red LED above this button indicates a
greater degree of sharpened pitch). CENTER TUNER LED (DD) illuminates green when correct pitch is attained. See "Looper"
section for looper "UNDO" function of this button/LED.
DD: CENTER TUNER LED: In tuner mode, illumination of this green LED indicates correct pitch

FOOTSWITCH

4