Installation Procedure - imacon Flextight Photo Mode D'emploi

Installation Procedure

1. Unpack your scanner and place it on a table near your computer
with the front side (the side with the red button) facing away from
you. Make sure that the location you choose meets all of the
requirements outlined above for temperature, stability, and electro-
magnetic interference.
2. IMPORTANT: Make sure that your scanner, your computer and all
devices connected to the SCSI chain are switched off. You can dam-
age your equipment if you make or break SCSI connections to or
from units that are turned on.
3. Locate the connectors in the recessed area located at the bottom of
the back of the scanner. You will see two SCSI connectors and a
round power connector (see ÒBack Panel & ConnectorsÓ on
page 9).
4. IMPORTANT: On the back of the scanner is a small dial, which is
used for setting the SCSI address for the scanner (see Figure 3).
Make sure that each device in your SCSI chain has been assigned a
different SCSI address. If necessary, use small screwdriver adjust
the wheel so that it points to a new address for the scanner. Use
only 0, 1, 2, 3, 4, 5, or 6. Do not use 7, 8, or 9.
Figure 3: SCSI address selector
5. Connect a SCSI cable to one of the SCSI connectors on your scan-
ner. Connect the other end of the cable to your computer or to the
last SCSI device in your chain.
6. Make sure your SCSI chain is terminated correctly. This means that
the empty connector on the last device in your SCSI chain must be
Þtted with a terminator. If your chain is not terminated, your com-
puter system may not work properly.
Imacon Flextight Photo UserÕs Guide
Hardware ReferenceÑFlextight Photo
Setting up the Scanner
11