Topcom Agia Mode D'emploi page 23

Agia
Toll saver
Your unit will answer after 2 rings if you have received messages and 4 rings if
there are no messages.
HINT: Hang up after the third ring to save time and phone charges.
Remote message and memo play back
1. Dial your telephone number.
2. Press the * button followed by the security code on hearing your OGM.
3. On hearing 2 beeps, press "1". The microcassette tape will rewind and play
any messages.
4. During play back:
a Press "7" to fast forward the tape. Press "8" to resume normal play.
b Press "9" to rewind the tape. Press "8" to resume normal play.
c Press "8" to stop. Press "1" within 8 seconds to replay from the beginning.
5. Hang up your telephone on hearing 2 BEEPS at the end of the last message.
Your machine will then automatically reset to receive new messages. Old
messages will be erased by new ones unless they are saved.
To save messages after play back
1. Press "4" within 9 seconds after hearing 2 BEEPS at the end of the last
message.
2. Hang up the phone.
To erase messages
If, after saving the old messages, you change your mind and want to ERASE
them, before hanging up, press "6". The tape will rewind to start, and your old
messages will be erased as new messages are recorded.
40
Agia
To change the OGM by remote control
Because your machine features variable length (VOX) on both incoming (ICM) and
outgoing (OGM) messages, you must be certain there are no ICM's before you
change your OGM.
1. Dial your telephone number.
2. If your machine answers in 2 rings, follow the steps in "Remote message and
memo play back" to listen to your ICMs.
3. Call your machine again and it will answer in 4 rings (no ICMs).
4. Pres the * button followed by the security code.
5. On hearing 2 beeps, press "3".
6 . Dictate your new OGM after hearing a single BEEP tone.
7. Press "3" when you have completed your new OGM.
8. Your new OGM will be played automatically for your checking.
9. Hang up the handset if your new OGM is acceptable.
Call Break Trough (CBT)
Imagine that it is night, everybody at home is asleep. The telephone has its Ringer at
OFF position and the volume control of the answering machine is at minimum. Or,
you know someone is at home, but they do not answer when you call (your machine
answers). With CALL BREAK THROUGH you can command this machine to emit loud
BEEPS for 1 minute to alert them to pick up your call.
To switch on CBT
1. Dial your telephone number.
2. On hearing your OGM, press the *-button followed by the CBT code. This unit is
factory preset with Code 168. However, this CBT code can be changed.
3. The CBT beeper will sound.
4. Press the ASTERISK to stop the CBT beeper when someone answers your call.
5. The called party can also stop the CBT beeper after having picked up, by pressing
the STOP button .
(6)
41