PLAYKIN FASTER Mode D'emploi page 54

ASSEMBLY FOOTRESTS
×
Turn the body of the vehicle.
1. The M10X190 bolt (this bolt is used to
assemble the handlebar, see next page) was
placed in the hole in the vehicle body at the
factory. Remove it before attaching the foot
plates.
2. Tighten a Ø10 lock nut on one end of the foot
plate shaft with a pipe wrench.
2
3. Slide a footplate (larger end outward) onto the alxe footplate. Insert the axle of the footrest
into the hole in the vehicle body, making sure the square end of the footrest is inserted into
the slot in the vehicle body. Continue to push the axle of the footrest as it passes through the
vehicle body.
4. Slide a foot plate over the foot plate axle from the other side of the vehicle body.
5. Tighten a Ø10 safety nut to the end of the footrest axle with a pipe wrench.
NOTE: An additional pipe wrench is provided to hold the lock nut on the other side of the
front axle while tightening the lock nut on the other side.
3
1
Remove bolt M10X190
4
5
54 54
Necessary tools:
Pipe Wrench x2
ES