Dremel 231 Consignes De Fonctionnement/Sécurité page 8

Masquer les pouces Voir aussi pour 231:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DM 2610914511 03-08
Fig. 10
1-1/2" Slot to Clear Guard
3/8" Plywood
Do not place material
!
WARNING
between router bit or
accessory and fence while routing or
sanding edge. This placement may cause
material to wedge making kickback possible.
Routing Using Pilot Bits
1. When bits with pilots are to be used, move
the fence back only enough to allow the
amount of cut to be made. Keeping the
fence close to the bit allows the fence to
serve as a rear guard. In special cases
when the fence must be removed from the
table, adjust the center cylinder of the
guard down to provide protection from
revolving cutter.
2. Only piloted bits can be used without the
fence. The workpiece should be kept
between the cutter and the operator, and
fed from right to left.
3. Feed the workpiece past the cutter without
stopping and with a consistent speed. A
change in feed or a dwell will cause an
irregular cut.
Expanded Table Work Surface
The shaper/router table is designed to easily
expand the size of the working surface. Use
3/8" thick solid core plywood. Cut a rectangular
hole in the plywood to fit over the table and
3/11/08
1:39 PM
16"
Page 8
1-1/2" High Supports
on Both Ends Will Rest on Bench
secure using (8) #10 wood screws, 1/2" in
length. Support the table at both ends by
securing 1-1/2" high lumber supports to the
plywood base. (See Fig. 9)
(Hardware not included)
Drum Sanding
The Shaper/Router Table is also ideal for drum
sanding irregular shaped parts as shown. Use
Drum Sander 407 (1/2") or 430 (1/4"), with or
without the fence assembly. (See Fig. 10)
Fig. 11
8
12"
1-1/2"
Rectangular Hole
to Fit Over Table

Publicité

Table des Matières
loading

Table des Matières