General Information - Lippert PROJECT 2000 Manuel D'utilisation Et D'entretien

!
The ELECTRONIC STEPS, like all the apparatuses with parts in motion,
can be font of serious danger if they aren't used in properly and/or protected way.
The customer must guarantee that:
• all the operations of transport, lacing, maintenance and reparation are performed from qualified and authorized personnel.
• We consider qualified personnel (as per current IEC standards) those persons who are able to effect every necessary interven-
tion recognizing and avoiding each possible danger and/or damage.
• This is possible thanks to their formation, education, experience, acquaintance of norms, antiaccident regulations and condi-
tions of use and service.
The manual should be conserved for the entire life of the step and should be given to any other user or subsequent owner.
The information given in this manual does not take the place of the safety rules and the technical data for installation and operation,
applied directly to the product or to the packing crates.
This manual reflects the state of the technology at present, and cannot be considered inadequate only due to subsequent updating
based on new experience.
The manufacture is, moreover, entitled to modify the manual without being obliged to update previous.
Improper use of the step or utilization other than that specified in this manual will nullify any term of guarantee or liability to the
manufacturer. The step should be utilized by adult, responsible persons.
This manual must be carefully conserved, since the manufacturer is not liable for damage caused to persons or things, or damage
undergone by the step if utilized in any manner other than that described or if the maintenance and safety prescriptions are not
respected.
Knowledge of the product and observance of the instructions contained in this documentation are necessary conditions to guaran-
tee the requisites for safety and correct operation.
It is therefore necessary to scrupulously follow the instructions given here.
For any problem or failure that might occur, apart from routine maintenance, contact our "Customer Assistance Service" directly, to
avoid possible alterations in the safety, reliability and functionality of the product.
In any case, all work on the product must be carried out only by qualified, authorized personnel.
The products have been designed and manufactured in compliance with Directive 2006/42/CE and UNI EN 1646-1 regula-
tion current legislation.
No safety device may be removed or modified by the purchaser:
The manufacturer declines any responsibility in case of failure to observe this prohibition.
Any possible modification, which does not impair the existence and the efficiency of the devices installed, must in any case
be submitted to the approval of the manufacturer and to inspection by the proper agencies, according to law, under the
purchaser's responsibility and at his expense.
For the various components of the steps, the manufacturer furnishes a guarantee of one year against manufacturing de-
fects.
This manual must always be available to the user and/or maintenance technician, who must be informed as to the correct
use of the product and any residual risks.
The manual should be conserved in a dry, clean place, protected from heat.
Utilize the manual in such a way as to avoid damaging its content, in whole or in part.
Do not remove, tear out or rewrite parts of the manual, for any reason. If the manual should be lost or further information
be required, contact the retailer for your territory or the manufacturer.
2.1 IDENTIFICATION DATA OF MANUFACTURER AND OF PRODUCTS.
MANUFACTURER: PROJECT 2000 S.r.l. Via Vivaldi 40/A – IT 50041 CALENZANO (FI)
Rev: 02.21.22
WARNING!

2.0 GENERAL INFORMATION

ELECTRONIC, ELECTRIC AND MANUAL STEPS
Page 5
CCD-0004515