Silverline 521457 Mode D'emploi page 8

GB
Troubleshooting
Problem
Red LED (16) and Green LED (15)
do not illuminate to indicate the
battery is charging correctly
Battery pack has low capacity
Drill cannot be switched on
(Trigger Switch (11) does not
move)
Drill does not start when Trigger
Switch is depressed
Screws do not reach deep
enough into the workpiece
Screws are driven too deep into
the workpiece surface
8
Possible cause
Battery (10) not correctly connected to Battery
Charger (13)
Battery Charger not powered
Battery not being fully charged
Battery pack has been charged over 100 times and
capacity has started to reduce
The Forward/Reverse Switch (7) may be in the middle
('locked') position
Battery completely discharged
Defective Battery
Tool defective
Not enough torque; torque clutch setting too low
Low battery voltage
Too much torque; torque clutch setting too high
Solution
Clean battery socket of charger and battery contacts and fully slide on to
Battery Charger so it clicks in a locked position
Recheck mains connection
Do not remove Battery until a full charge is indicated
This is normal for battery packs. Contact your Silverline dealer to purchase a
replacement battery pack
Slide the Forward/Reverse Switch either to the left or right
Recharge Battery or replace with a fully charged Battery
Replace Battery
Contact your Silverline dealer or authorised service centre
Choose a higher torque setting
Recharge battery or replace with a fully charged battery
Choose a lower torque setting