Porter Cable NS100A Manuel D'instructions page 5

Masquer les pouces Voir aussi pour NS100A:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fig. 10
16. REMOVE FINGER FROM TRIGGER
when not driving fasteners. Never carry tool
with finger on trigger: tool may fire a fastener
if safety is bumped while trigger is depressed.
Fig. 10.
17. DON'T OVERREACH. Keep proper
footing and balance at all times when using
or handling the tool. Fig. 11.
18. FIRE
FASTENERS
SURFACE ONLY: never into materials too
hard to penetrate. Fig. 12.
19. GRIP TOOL FIRMLY TO MAINTAIN
CONTROL WHILE allowing tool to recoil
away from work surface as fastener is driven.
If safety element is allowed to recontact
work surface before trigger is released, an
unwanted fastener may be fired.
20. DO NOT DRIVE FASTENERS on top of
other fasteners, or with the tool at too steep
an angle: the fasteners can ricochet causing
personal injury. Fig. 13.
21. DO NOT DRIVE FASTENERS CLOSE
to the edge of the workpiece. The workpiece
is likely to split allowing the fastener to fly free
or ricochet causing personal injury. Fig. 13.
22. KEEP HANDS AND BODY PARTS away
from area shown in Fig. 13A, to avoid injury.
23. DO NOT USE ON SCAFFOLDINGS OR
LADDERS or for tasks in which changing
location involves the use of scaffoldings,
stairs, ladders, and the like. Do not use
for specific tasks such as closing boxes or
crates or fitting transportation safety systems
on vehicles and wagons. Fig. 13B.
INTO
WORK
4
Fig. 11
Fig. 12
Fig. 13
Fig. 13A
Fig. 13B

Publicité

Table des Matières
loading

Table des Matières