Service And Repairs - Porter Cable NS100A Manuel D'instructions

If tool is used without an in-line oiler: place 5 or 6 drops of Porter-Cable Air Tool
Oil into the air inlet of the tool at the beginning of each workday.

SERVICE AND REPAIRS

All quality tools eventually require servicing or replacement of parts due to
wear from normal use. Some user serviceable components are described in
the TROUBLESHOOTING Section. Complete product Service is available from
either an AUTHORIZED PORTER-CABLE SERVICE STATION or a PORTER-
CABLE SERVICE CENTER. All repairs made by these agencies are fully
guaranteed against defective material and workmanship. We cannot guarantee
repairs made or attempted by anyone other than these agencies.
Should you have any questions about your tool, feel free to write us at any time.
In any communications, please give all information shown on the nameplate of
your tool (model number, type, serial number, etc.).
CAUTION: Disconnect tool from air supply before performing any
Service Procedure.
SYMPTOM
1. Air leak near top of
tool or in trigger area. Worn or damaged
2. Tool does nothing or
operates sluggishly.
"DRIVER" Maintenance Kit.
3. Air leak near bottom
of tool.
4. Tool jams frequently.
5. Other.
TROUBLESHOOTING
PROBLEMS
Loose screws.
o-rings or seals.
Inadequate air supply.
Inadequate lubrication.
o-rings or seals.
Loose screws.
Worn or damaged
o-rings or bumper.
Incorrect fasteners.
Damaged fasteners.
Magazine or nose
screws loose.
Magazine is dirty.
Driver is worn or damaged.
9
SOLUTIONS
Tighten screws.
Install "OVERHAUL" Maintenance Kit.
Verify adequate air supply.
Put 5 or 6 drops of oil into air inlet.
Worn or damaged
Tighten screws.
Install "OVERHAUL" Maintenance Kit.
Verify approved fasteners of
correct size.
Replace w/undamaged fasteners.
Tighten screws.
Clean magazine.
Install "DRIVER" Maintenance Kit.
Contact a Porter-Cable
Service Facility.
Install