Fit the C0
valve and the C0
the direction of flow, see the arrow on the housing.
Use only original EHEIM C0
installation. Unsuitable hoses may burst.
Keep the C0
short as possible as overpressure builds up with a closed solenoid valve.
On opening the solenoid valve the briefly increased volume of C0
aquarium is reduced.
A
Connect the mains plug of the solenoid valve to the timer switch. The sole-
noid valve opens as soon as it is supplied with power and the addition of
C0
begins.
2
B
Connect the mains plug of the EHEIM powerLED+ power supply unit to the
timer switch. Connect the plug connection of the EHEIM powerLED+ lamp
and the plug connection of the solenoid valve using a Y-distributor and plug
it into the power supply unit of the powerLED. The solenoid valve opens as
soon as it is supplied with power and the addition of C0
C
Connect the EHEIM powerLED+ power supply unit to the EHEIM LEDcontrol+
light controller. Connect the plug connection of the EHEIM powerLED+ lamp
and the plug connection of the solenoid valve using a Y-distributor and plug
it into the EHEIM LEDcontrol+. As soon as the white LEDs of the EHEIM
powerLED+ lamps reach a light intensity of more than approximately 30%
the solenoid valve is supplied with power and the addition of C0
Only increase the C0
Apply the EHEIM C0
amount of C0
7.
Special Instructions
• In order to avoid noise through resonance transmission, do not install the C0
noid valve on thin underlays (for example, wood or plastic panels).
• Only operate the C0
been designed especially for the supply of C0
• In order to prevent corrosion, protect the C0
valve. Non-return air valves for commercially available air diaphragm pumps are not
suitable as, due to the C0
non-return valve in the hose installation between the solenoid
2
feed unit (for example a C0
2
hose between the pressure reducer and the solenoid valve as
2
supply gradually and spread over several days.
2
long-term test for the determination of the correct
2
.
2
solenoid valve together with a C0
2
, they begin to leak after a short operating period.
2
-Safe Ø 4/6 mm hoses for the complete hose
2
to aquaria.
2
solenoid valve using a C0
2
15
diffusor). Pay attention to
2
begins.
2
pressure reducer which has
2
2
in the
2
begins.
2
sole-
2
non-return