How To Use - Noco BOOST MAX GB500+ Guide D'utilisation Et Garantie

beam at the highest setting. Cleaning. Power off the product before attempting any maintenance or cleaning. Clean and dry product immediately if it comes in
contact with liquid or any type of contaminant. Use a soft, lint-free (microfiber) cloth. Avoid getting moisture in openings. Explosive Atmospheres. Obey all signs
and instructions. Do not operate product in any area with a potentially explosive atmosphere, including fueling areas or areas which contain chemicals or particles
such as grain, dust or metal powders. High-Consequence Activities. This product is not intended for use where the failure of the product could lead to injury,
death or severe environmental damage. Radio Frequency Interference. Product is designed, tested, and manufactured to comply with regulations governing
radio frequency emissions. Such emissions from the product can negatively affect the operation of other electronic equipment, causing them to malfunction.
Model Number: GB500. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment
has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his/her
own expense.

How To Use

Step 1: Charge the GB500.
The GB500 comes partially charged out of the box and needs to be fully charged prior to use. Connect the GB500
using the included 12V Adapter or 56W XGC Power Adapter to the 12V IN port. The GB500 must be in 12V mode to
be charged. Ensure the voltage selection knob is in the 12V position prior to charging. The XGC 12V IN port is rated at
12V, 5A to ensure safe and efficient charging of the internal lithium battery. Due to FCC regulations, we recommend
not to charge and discharge the unit at the same time. The time to recharge a GB500 will differ based on the discharge
level and the power source used. Actual results may vary due to battery conditions.
When recharging, the charge level of the internal battery is indicated by the Charge LEDs. The LEDs will slowly pulse "On" and "Off", and
become solid until all four Charge LEDs are on. When the battery is fully charged, the Green 100% LED will be solid, and the 25%, 50%
and 75% Charge LEDs will turn "Off". From time to time, the Green 100% LED will pulse indicating maintenance charging is occuring.
25% 50% 75% 100%
Recharge Time: 6-8hr
Using 12V DC Cable or AC Power Adapter to
recharge a fully discharged unit. Recharge
time will vary based on level of discharge.