SEVERIN ES 3563 Mode D'emploi page 10

short-term operation only, i.e. it should not
be operated continuously for more than 2
minutes. Allow it afterwards to cool down
suffi ciently before switching on again.
Before using for the fi rst time
Before the appliance is used for the fi rst
time, it must be cleaned as described in the
section Cleaning and care.
Switch
The appliance is equipped with a 3-position
switch.
0 appliance switched off
1 slow juice extraction
2 fast juice extraction
Operation
∙ Place the fi lter holder onto the drive unit.
∙ Fit the fi lter into its holder, pushing it fi rmly
down until it is heard locking into place.
It is important that the fi lter is securely
attached and not at an angle.
∙ Slide the pulp container on the left side on
the unit under the rim of the fi lter holder,
tilting the container slightly.
∙ Place the transparent lid onto the fi lter
holder. The left side of the lid must
engage in the pulp container. Secure the
lid with the locking clip, which will activate
the safety switch. Ensure that the locking
clip engages fi rmly on both sides into the
locking recesses on the lid.
∙ Slide the splash guard onto the juice
outlet and place the juice container below
the outlet.
∙ Insert the plug into the wall outlet and put
the switch to the required setting.
∙ Feed the clean, pre-cut fruit or vegetable
pieces down the feeder tube while the
unit is running. Use the pestle to push the
10
pieces down lightly, observing the arrow
mark and the guide slot on the pestle.
Caution: Excessive pressure may result
in damage to motor or fi lter.
∙ When processing large quantities of fruit
or vegetables, the pulp container and
juice container must be emptied from time
to time as necessary.
∙ After use, switch the appliance off and
remove the plug from the wall socket.
Juice container
The juice container incorporates a
removable foam screen. If the juice is poured
out carefully, the foam caused during juice
extraction will remain inside the container.
Cleaning and care
∙ Always remove the plug from the wall
socket and allow the appliance to cool
down before cleaning.
∙ Please note: the fi lter has small, sharp
points. There is a risk of injury.
∙ Do not use abrasives, harsh cleaning
solutions or hard brushes for cleaning.
∙ To avoid the risk of electric shock, do not
clean the drive unit with water and do not
immerse it in water.
∙ The drive unit may be wiped with a
slightly damp, lint-free cloth.
∙ The pulp container, fi lter holder, splash
guard, lid, pestle and juice container may
all be cleaned using hot water and a mild
detergent.
∙ The fi lter should also be cleaned each
time after use, using a soft, commercially
available nylon brush. Do not clean the
fi lter with any hard object, as that may
render it unusable.
∙ These parts are not dish-washer safe.
∙ Cleaning of the pulp container is greatly