IKEA UNDVIKA Mode D'emploi page 7

power is on, the battery indicator (12) lights up green. If the indicator starts
blinking red, the unit needs to be charged.
2. Y ou can adjust volume of the speaker (17) from 1 (lowest) to 3 (highest) using
the Volume control (10).
3. W hen a signal is received, the Sound level indicator (13) will light up in three
levels depending on the intensity of the sound transmitted from the baby unit.
At level 3 the unit will also vibrate.
This indicator is useful for monitoring your child when the volume of the
parent unit is set on low.
4. W hen the parent unit is in contact with the baby unit, this is indicated by a
green steady light on the Range indicator (15). If the units are out of contact
with each other the range indicator will start blinking red. There will also be a
beeping signal to alert your attention. This signal is also activated if the baby
unit is switched off.
5. Y ou can talk to your baby through the parent unit to the baby unit by holding
the Talk back button (16).
6. Y ou can carry the parent unit with you by attaching the Rubber ring (14). To
remove the rubber ring, bend it outwards and pull it off the unit.
Charging
Baby unit:
When battery is low the battery symbol will flash red. Connect a power supply to
the input connector (2).
Parent unit:
When battery is low the battery symbol will flash red. Place parent unit in baby unit
docking connector (7) or connect a power supply to the USB-C connector (11).
For charging, use only NIMH type AAA/HR03 rechargeable batteries.
Do not attempt to charge other types such as Alkaline, Carbon Zink etc. The baby
monitor has built in protection and will detect wrong battery types. The battery
symbol (4) will indicate error by flashing.
7