Russell Hobbs 21340-56 Mode D'emploi page 4

11 Push the bottom of the shaft into the top of the body.
12 Rotate the shaft till the pip engages with the hole in the body.
13 Wind the cable round the cable hooks.
C THE CLOTH
14 Loosen the ties.
15 Fit the cloth over the base.
16 Bring the edges of the cloth up and over the flange running round the base.
17 Tighten the ties to secure the cloth to the base.
C FILLING – WATER
18 Pull the water reservoir up and off the body.
19 Turn the reservoir upside down, and unscrew the cap.
20 Lift the cap and tube out of the reservoir.
21 Fill the reservoir with fresh cold water.
, Don't add anything to the water – you may damage the appliance, you will destroy the
anti-scale cartridge.
22 Slide the tube into the reservoir, and screw on the cap.
23 Turn the reservoir right way up, and replace it in the body.
C FILLING – DETERGENT
24 Turn the detergent valve to ].
25 Pull the detergent reservoir up and off the body.
26 Turn the reservoir upside down, and unscrew the cap.
27 Lift the cap and tube out of the reservoir.
28 Dilute the detergent in accordance with the manufacturer's instructions.
29 Fill the reservoir with the diluted detergent.
30 Slide the tube into the reservoir, and screw on the cap.
31 Turn the reservoir right way up, and replace it in the body.
C TILT OR LOCK?
32 The joint where the body meets the base has two positions.
33 Hold the front of the base gently with a foot while changing positions.
34 Push the handle forward to lock the handle/body upright.
35 Pull the handle back to unlock the handle/body, so the base moves freely (like an upright
vacuum cleaner).
C USING THE CARPET GLIDER
36 If you're going to clean carpet, rest the base and cloth in the carpet glider.
37 This will reduce drag, and make moving the mop much easier.
C SWITCHING ON
38 Rotate the top cable hook, and remove the cable from the hooks.
39 Push the body end of the cable into the pinch in the tip of the top cable hook, to help keep it
out of your way.
40 Put the plug into the power socket.
41 The power light will glow as long as the appliance is connected to the electricity supply.
42 The thermostat light will glow when the appliance reaches working temperature.
43 It will then cycle on and off as the thermostat operates to maintain the temperature.
C IN USE
44 Wait till the thermostat light glows.
45 Unlock the handle/body to allow the base to move freely.
46 Hold the appliance by the handle.
47 If you're using detergent, turn the detergent valve to [, to allow the detergent to flow into
the base.
4