Ecolab CoolPROTECT Notice Technique page 57

8.3.3.5 Change access code (if it was activated before)
Fig. 8.11 Overview
1. Entry to the access code function is to be carried out as in chapter: 8.3.3.1.
2. The display shows: DEACTIVATE ACCESS CODE
3. Pressing the „NEXT-Key" leads to the function CHANGE ACCESS CODE.
Activate the function by pressing the „Enter-Key ↵".
4.
The display shows INPUT OLD CODE
Enter the first of the four code numbers by pressing this
Then press the Enter-Key ↵. Then the second field will flash.
The following digits are to be entered analogously.
5. Press the NEXT-Key to confirm.
6. If the entered code is wrong the display shows WRONG CODE NUMBER.
This display is confirmed by pressing the NEXT-Key and leads back to the
display
CHANGE ACCESS CODE.
7. If the right access code was entered the display shows INPUT NEW CODE.
Enter the first of the four new code numbers by pressing this
Then press the Enter-Key ↵. Then the second field will flash.
The following three digits are to be entered analogously.
8. Press the NEXT-Key to confirm.
The display again shows CHANGE ACCESS CODE.
9. Pressing the „NEXT-Key" one more time leads back to the ACCESS CODE
FUNCTIONS.
417101555_CoolProtect.doc - 57 -
or this key.
or this key.
Rev.: 08-06/10