Cleaning And Maintenance - Bimar UM5 Notice D'instructions

3. Place the receptacle on its base in the correct manner: ensure that the two arrows match up (on
the base and on the receptacle, found at the back).
4. Ensure that the knob is in the "0" position (off): and most importantly that the water has not
overflowed.
5. Plug the appliance in.
6. Turn the knob (3) in a clockwise direction to the "min" position and corresponding to the
amount of nebulisation required: minimum, intermediate or maximum. After a few seconds,
vapour will start forming.
7. When the water runs out, the nebuliser will automatically stop: to fill up the receptable again,
follow the instructions above in paragraphs 1, 2, 3 and 4.
8. For ozonation, press the "ozone" button (9) completely. To stop it, press it again and release.
9. To diffuse perfumes, extract the filter carrier from the base (11), moisten the felt (12) with a
few drops of essential oils and insert the filter carrier once again in its proper place. Be careful
not to add too much oil so as to prevent damage to the surface and the appliance itself. Do not
add the essential oils to the water in the receptacle or inside the unit.
10. In order to turn the appliance off, turn the knob to the "0" position, turning it in an
anticlockwise direction and unplug the unit from the power source.
11. After each use, empty out any water that may have collected in the tray inside the base and
dry it using a soft cloth
If the device is not to be used for a long time, remove the plug from the electric outlet and
make sure the tank and inside of the base are perfectly dry.
Warning: if you do not plan to use the appliance for two or more consecutive days, make sure
that the tank and the tray have been completely drained. Dry them to prevent the formation of
bacteria and algae in the stagnant water

CLEANING AND MAINTENANCE

Warning: before cleaning the applinace ensure that it is turned off and unplug it from the
power source.
Descaling
13/36