Charging Up The Battery; Trimmer Unit 1 X; Use - MAXXMEE GT100 Mode D'emploi

Cordless Lawn Trimmer
CHARGING UP THE
BATTERY
Please Note!
■
Only connect the battery charger to a
plug socket that is properly installed
and matches its technical data. The
plug socket must be readily accessible
after connection so that the connection
to the mains can quickly be isolated.
■
Only use suitable extension cables
whose technical data is the same as
that of the battery charger.
■
Pull the battery charger out of the
plug socket if an error occurs during
charging or before a thunderstorm.
■
Only ever charge up the battery using
the battery charger that is supplied
(WJG-Y091260500WZ). Do not use
the battery charger that is supplied to
charge up any other devices.
It is essential that you charge up the
battery fully before you fi rst use the
device in order to achieve the maximum
charging capacity.
 
If the battery is fully discharged
during use, it must be fully
charged up again before it is next
used.
We recommend detaching the telescopic
rod (5) from the trimmer unit (11) prior
to charging to prevent the device from
accidentally being switched on.
1. Pull the silicone cover off the charging
socket (13).
2. First plug the barrel connector of the
battery charger into the connecting
socket and then plug the battery
charger into a plug socket. The
control lamp on the battery charg-
er lights up red during the charging
process.
When the control lamp lights up
green, the battery is fully charged.
3. First disconnect the battery charger
from the mains power and then dis-
connect the barrel connector from the
trimmer unit (11).

USE

Please Note!
■
Always remain alert while using the
device. Only work with good visibility
and light conditions.
■
Do not use the device in poor weather
conditions, in particular not if there is
an imminent risk of lightning.
■
Always inspect the area you are
working in – clear any coarse dirt
and objects lying around which may
be spread around by the device or
become caught in the device.
■
After the device is switched off, the
cutting elements continue to rotate
for a few more seconds. Wait until
they have come to a complete stand-
still.
■
Only place down the device once
the cutting elements have come to a
complete standstill.
■
Always switch off the device before
leaving the area you are working in,
e. g. when crossing paths or similar
terrain.
■
Never use the device without or with
a damaged protective cover.
■
Always guide the device using two
hands. Always keep the handle and
the gripping surface dry, clean and
free of grease to ensure that the
device can be held securely and fi rmly
during use.
■
If there is an imminent danger or in
an emergency, switch the device off
immediately and detach the trimmer
unit from the telescopic rod.
■
Comply with any country-specifi c or
municipal regulations governing lawn
trimming.
EN
21