Before Initial Use; Mounting And Settings Of The Device - MAXXMEE GT100 Mode D'emploi

EN

BEFORE INITIAL USE

• Assemble the device (see the
"Mounting and Settings of the
Device" chapter – "Assembly").
• Attach cutting elements (see the
"Mounting and Settings of the
Device" chapter – "Attaching /
Detaching Cutting Elements").
• Charge up the battery (see the
"Charging Up the Battery" chapter).
MOUNTING AND
SETTINGS OF THE DEVICE
Assembly
1. Place the edge guide (7) with the
inwardly curved side at the bottom on
the trimmer unit (11) and press it on.
When you do this, make sure that the
castor of the edge guide is pointing
to the front left.
2. Place the protective cover (8) with the
outwardly curved side at the bottom
on the edge guide and press it on.
When you do this, make sure that the
protective cover is oriented backwards.
3. Use the two screws and the tool which
is supplied to screw the protective
cover and the edge guide on the
trimmer unit.
4. Insert the telescopic rod (5) into the
corresponding mount on the trimmer
unit. You must hear and feel it engage.
Proceed in the reverse order to take it
apart. Please Note: To detach the tele-
scopic rod, press the release button (6)
and pull the telescopic rod out of the
trimmer unit at the same time.
20
Attaching / Detaching Cutting
Elements
The device can be used both with cable
ties and with a trimmer thread as the
cutting element. These are attached as
follows:
1. Lay down the trimmer unit (11) so that
the bottom is facing upwards.
2. Hold the rotatable end piece of the
trimmer unit securely with one hand
and at the same time undo the lock-
ing screw anticlockwise and remove it.
3a. Introduce two cable ties into the
recess of the thread (A) and fi x them
with the locking screw (B) (Picture B1
+ B2) OR
3b. Introduce one trimmer thread into
the recess of the thread (A) and fi x it
with the locking screw (B) (Picture C1
+ C2). When you do this, make sure
that the marking on the trimmer
thread is positioned in the thread.
Proceed in the reverse order to remove.
Adjusting the Telescopic Rod
(Picture D + E)
The length of the telescopic rod (5) can
be varied, which means it can be individ-
ually adjusted to suit your body size.
1. Undo the fi xing (4) by turning it clock-
wise (towards the
2. Extend the telescopic rod to the
length you want.
3. Twist the fi xing anticlockwise to secure
it (towards the
symbol).
symbol).