Printing Operation; Exchange Heat Element And Work Plate; Build In And Extend A Heat Element; Build In And Extend A Work Plate - SCHUSTER T Serie Mode D'emploi

TP-54 Solo / TP-54 Twin

5 Printing Operation

After you adjusted your settings and the temperature is
reached (the light-emitting diode "O.K." will flash) –
now you can begin with your printing operations.
1. If you have a TP-54 Solo; pull the sliding table
out.
2. If you have a TP-54 Twin; pull the double
sliding table to the left or right until it blocks.
3. Arrange the item and the corresponding artwork
onto the work plate.
Please note following points for an optimal print
result and to prevent from damage:
Objects which (in a pressed condition) are not
thicker than 5mm and do not cover the whole
work plate; have to be placed into the center of
the work plate. If it is not possible to centre the
object, you have to cover the empty spaces with
pads (of the same size).
Again, be aware of the damage which may
occur from non-observance.
4. If you have a TP-54 Solo; push the sliding table
back into the transfer press until it blocks.
5. If you have a TP-54 Twin; pull the double
sliding table towards the opposite side until it
blocks.
6. Confirm both starter buttons at the same time.
7. The heat element will lower and start the
operation. After the printing time is over, the
heat element will rise automatically and you
will hear a beep.
6 Exchange Heat Element and
Work Plate

6.1 Build In and Extend a Heat Element

Before you start to extend the heat element,
assure yourself that the heat element has cooled
down to room temperature.
1. At first remove the heat element plug. To do so;
you first of all have to loosen the corrugated-
head screw of the heat element plug with a
phillips screwdriver. Remove the heat element
plug from the outlet.
2. Now you have to loosen both retaining screws
of the heat element with a 13-way spanner, and
unscrew it for approximately 3-4 mm.
holding
screw
3. Lift up the heat element and pull it towards you.
4. To build in a heat element, do the same process
in reversed order.

6.2 Build In and Extend a Work Plate

retaining screws
Loosen both retaining screws on the underside of the
work plate, then just pull the plate out towards you.
- 15 -
ENGLISH
heat element
plug