Checking Parts; Safety Instructions - Laserworld CS-250RGY Mode D'emploi

Warranty Label
Nicht entfernen / Do not remove
SerNo: ............
Don't remove the warranty/serial number label - removal voids warranty
When a cold laser is brought into warm/damp environment, don't turn it on immediately. Condensation
water could damage the laser.
Use a power socket with earth/ground. Don't use dimmer, RC, or other electronically switched sockets.
Whenever possible, don't use the laser together with large appliances, especially fog machines, on the same
mains!
To ensure maximum lifetime of the laser:
Don't overheat the laser:
•
Always ensure good ventilation
•
Don't have stage lights (especially moving heads) directed towards the laser
•
Regularly clean the fans and the interior from dust
•
In a new installation check the temperature after 30 minutes of operation
Keep the laser dry
•
Make sure fog/hazer fluid doesn't condensate inside the laser
•
Fog has to be in front of the laser – not inside
•
A few days after (each new) installation, open the cover to check if fluids condensate inside
•
If fluids condensate inside, reposition the laser or fogger/hazer
Turn the device off, when not used. The diode is on, when the device is on. Even if it is not lit.
Connect an emergency switch to the Remote lock connector on the backside (see picture). Connect the
switch to pins 1 and 2.
If no emergency switch is used, insert the 9 pin dongle instead. (Picture below)

Checking Parts

Please make sure the following parts are included:
1 x Laser projector
1 x Remote lock connector
1 x Key
1 x Power cable
1 x User manual
DANGER LASER RADIATION!
Avoid direct eye exposure!
Laser radiation can cause eye damage and/or skin damage
All protective measures for a safe operation of this laser

Safety instructions

If the device has been exposed to great temperature changes, do not switch it on immediately.
Condensation water may damage your device. Leave the device switched off until it has reached
room temperature.
The laser must only be used for shows. Any operation has to be attended and supervised by a
skilled and well-trained operator.
Never leave this device running unattended and keep it away from children and unauthorized
persons.
must be applied.
Important