Pingi VIDA 1S Mode D'emploi page 3

EN
PVDS-1000EU - DEHUMIDIFIER
BOX CONTENT
1.
1. PVDS-1000EU
2. Power adapter
3. Operating instructions
INTENDED USE
Your new Pingi Vida Dehumidifier (PVDS-1000EU) is suitable for dehumidifying enclosed indoor spaces.
The appliance is powered by the 9V AC-DC adapter that is supplied with the device. The power adapter
operates on 100-240V, 50/60Hz (mains electricity). Never try to connect the device or power adapter to other
power sources. Please always follow the safety instructions in this manual. Keep this instruction manual in
a safe place, so that it is available at all times. This product complies with regulatory, national and European
requirements. Never try to make technical modifications to this device. We do not accept liability for
accidents or damages resulting from failure to follow these operating and safety instructions.
FUNCTION AND APPLICATION
The Pingi Vida Dehumidifier (PVDS-1000EU) was developed as a compact dehumidifier that captures
excess moisture in indoor spaces. This product is ideally suited for unventilated indoor spaces. The captured
moisture is collected in the integrated tank.
BEFORE YOU START
Please carefully read the safety instructions on the front page of this manual before getting
started.
OPERATION
Powered on: The device is switched on by pressing the power button on the front of the device. The power
button will light blue. The blue tank light will also be activated. The appliance is now collecting humidity
from the ambient air.
Tank full: This appliance has an automatic shut-off function. When the tank is nearly full, the tank light will
change colour to red and the power button light will dim.
EMPTYING THE TANK
This device has a tank with a capacity of approximately 1000 ml. When the tank is nearly full, the appliance
will automatically shut off its dehumidifying functions and the tank light will change colour to red. Switch
off the appliance and carefully slide out the tank by pulling its handle. The small cap marked 'DRAIN TANK'
located on top of the tank can now be removed. Empty the tank into, for example, a kitchen sink. After
emptying the tank, please hold it upside down for a moment to pour out any remaining water. After draining
the tank, it can be replaced. The device can now be switched back on.
. .
2 3
Blue light
of
OPERATING INSTRUCTIONS
24/7 DRAINAGE
This appliance comes with a convenient 24/7 drainage option. You can attach a 010mm drainage tube (part
not included) to the tank and any collected water will flow out through the drainage tube. You can hang the
other end of the tube in for example a sink or large bucket. You will no longer have to empty the tank.
Attention: When the drainage tube is installed, it is no longer possible to slide the tank out of the device.
Remove the drainage tube before attempting to slide out the tank.
Attention - overflowing risk: Automatic shut-off will be bypassed when attaching the drainage tube.
Make sure to use a sufficiently large receptacle (bucket) and regularly check it, as it might overflow in time.
Tip: Save the rubber cap for later use.
Note: It is recommended to use the 24/7 drainage option with the VSB-1S wall mount (part not included)
only.
ADDITIONAL FEATURES
Day/Night-mode: The tank light can be dimmed by moving the night-mode slide to the right. The slide is
located on the front side above the tank.
DISPOSAL OF THE DEVICE
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection
facilities. Contact your local government for information regarding the collection systems
available. If electrical appliances are disposed of in landfills or dumps, hazardous substances
can leak into the groundwater and get into the food chain, damaging your health and well-
being. When replacing old appliances with new ones, the retailer is legally obligated to take
back your old appliance for disposal at least for free of charge.
CLEANING THE DEVICE
If necessary, wipe off the exterior of the appliance with a lightly dampened cloth.
LIMITED 2-YEAR WARRANTY
InnoGoods BV guarantees your appliance against material and fabrication faults for 2 years after initial
purchase. Should material or fabrication faults be found, InnoGoods will repair or replace the device with
a similar or better-specified product. Damage to the device due to any form of negligence, accident, lack of
cleaning and maintenance, or other use or abuse that can reasonably be considered to be in conflict with the
directions described in these instructions, does not fall under this warranty. Furthermore, legal provisions
with respect to consumer purchases apply. In the event of a fault, we advise you to return the product
together with the original proof of purchase to the store where you bought it. When the defect in the device is
caused by anything other than material or fabrication faults, you may be charged for examination and repair
costs.
Day-mode Night-mode
10mm