About Bridged Mode - Pioneer PRS-D800 Mode D'emploi

Section
02 Connecting the units
! Install and route the separately sold battery
wire as far as possible from the speaker wires.
Install and route the separately sold battery
wire, ground wire, speaker wires and the am-
plifier as far away as possible from the anten-
na, antenna cable and tuner.
! Avoid routing wires through hot areas, such
as near the heater outlet. Heat may damage
the insulation, resulting in a short-circuit
through the vehicle body.
Removal of the terminal cover
Before connecting and installing the amplifier,
you need to remove the terminal cover.
1 Slide the terminal cover outward (M) and pull it
toward (N) you.
Reattachment of the terminal cover
1 With the terminal cover slid open, attach the
cover as shown in the illustration below.
2 Press on the upper sides of the terminal cover
to make sure that the cover is firmly attached
to this unit.
3 Press on the lower sides of the terminal cover.
8
En
Make sure that the hook on the terminal cover
has been inserted firmly into this unit. Refer to
the illustration for details.

About bridged mode

The maximum speaker impedance is 4 W. Please
carefully check. Improper connection to the am-
plifier may result in malfunction or personal in-
jury due to burns from overheating.
For bridged mode for a two-channel amplifier,
with a 4 W load, either wire two 8 W speakers in
parallel, Left + and Right * (Diagram A) or use a
single 4 W speaker. For other amplifiers, please
follow the speaker output connection diagram for
bridging shown on rear: two 8 W speakers in par-
allel for a 4 W load or a single 4 W speaker per
channel.
For any further enquiries, contact your local
authorized Pioneer dealer or customer service.