Overheat Protection - oneConcept Heat Spike Mode D'emploi

EN
22
until the desired operation time is displayed. To cancel the timer feature
press the "-" button until all time indicator light off. This returns the heater to
continuous running. Each press increase 1 hour.
Temperature setting
1. The LED screen will display the room temperature, to adjust the
temperature, press "+" to increase the desired temperature and "-" to
decrease the desired temperature.
2. When the air temperature reaches 1 degree above the set temperature,
the heater will cut off. The heater stops working but the fan continues
working to allow the product to cool down and maintain the temperature.
3. When the air temperature drops 3 degrees below the set temperature,
the unit will come back on.
4. Temperature can be set from 10 degrees to 49 degrees, by pressing the
"+" and "-".

Overheat protection

This heater is protected by an overheat protection system that switches off the
appliance automatically in case of overheating, e.g. due to the total or partial
obstruction of the grids. In this case, unplug the appliance, wait about 30 minutes
for it to cool down and remove the object which is obstructing the grids. Then
switch it back on as described above. The appliance should operate normally.
Should the problem persist, please contact the nearest customer service centre.
NOTE: To assist in maintaining the internal components, after pressing the OFF
button the fan will continue to blow air for a period of 30-60 seconds before
going into standby mode.