Water Distribution Tube Cleaning; Ice-Making System Cleaning - Maxx Ice MIM50 Mode D'emploi

3. Gently take out the distribution tube.
4. With a brush, clean the tube with a dilute solution of warm water and a mild detergent such as
dishwashing liquid. After removing the dirt and lint from the surface, rinse the tube with clean
water.
5. Replace the distribution tube.
6. Reconnect the water supply.
Ice-making system cleaning and sanitizing
Minerals that are removed from the water during the freezing cycle will eventually form a hard,
scaly deposit in the water system. Cleaning the system regularly helps remove the mineral scale
buildup. How often to clean the system depends upon how hard your water is or how effective your
filtration may be. With hard water of 15 to 20 grains/gal. (4 to 5 grains/ liter), you may need to
clean the system as often as once every 6 months.
1.Make sure that all the ice is off the evaporator. If ice is being formed, wait until the cycle is
completed, then press the machine's ON/OFF switch on the control panel.
2.Remove all ice from the storage bin.
3.Keep the ice maker connected to the water supply. Pour 8 oz. of Nickel-Safe Ice Maker Cleaner
Solution into the water trough. Then press the ON/OFF switch and the CLEAN button, initiating the
wash cycle. The machine will run in the Automatic Clean Mode.
4.Allow 30 minutes for proper cleaning. After cleaning, press the ON/OFF switch again. Use a drain
hose on the front of the water trough to drain off the waste water to a convenient container.
NOTE: Don't drain off the waste water to the inside of the cabinet.
5.Repeat steps 3 and 4 (without Ice Maker Cleaning Solution) three times to rinse the ice making
system thoroughly.
 NOTE: Ice Maker Cleaner Solution in the water bin during the rinse is not needed.
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner products.
Use rubber gloves to protect hands. Carefully read the material
safety instructions on the container of the ice machine cleaner.
Discard the first batch of ice produced after cleaning.
1.Prepare a sanitizing solution made of 1 ounce of household bleach and 2 gallons of hot water (95º
to 115ºF). Wipe the entire bin inside and outside, covering the entire surface of the walls.
2.Fill a spray bottle with the sanitizing solution and spray all corners and edges, making sure to cover
all surfaces with the solution.
3.Allow the solution to be in contact for at least 3 minutes, then dry.
4. Repeat steps 1 to 5 with the sanitizing solution of step 6 replacing the Nickel Safe ice maker cleaner
solution and filling the water trough to its maximum level
20